260A01 | PCBセンサ・オンラインストア東陽テクニカ

Model: 260A01
Triax ICP® force sensor, 1k lb (Fz), 500 lb (Fx,y), 2.5 mV/lb (z), 10 mV/lb (x, y)

Specifications
アクセサリ
Product Documents

■ Specifications

Performance
Sensitivity (±20 %) (Z Axis)	0.56 mV/N	[3] [4]
Sensitivity (±20 %) (X or Y Axis)	2.25 mV/N	[3] [4]
Measurement Range (Z Axis)	4.45 kN
Measurement Range (X or Y Axis)	2.22 kN
Maximum Force (Z Axis)	5.87 kN
Maximum Force (X or Y Axis)	2.94 kN
Maximum Moment (Z Axis)	18.98 Nm
Maximum Moment (X or Y Axis)	17.63 Nm
Broadband Resolution (z axis)	0.027 N-rms	[2]
Broadband Resolution (x or y axis)	0.0089 N-rms	[2]
Upper Frequency Limit	90 kHz
Low Frequency Response (-5 %) (Z-Axis)	0.01 Hz
Low Frequency Response (-5 %) (X or Y Axis)	0.001 Hz
Non-Linearity	≤1 % FS	[1]
Cross Talk (between X and Y Axis)	±3 %
Cross Talk (between (X or Y Axis) and Z Axis)	±5 %
Environmental
Temperature Range	-54 to +121 °C
Electrical
Full Scale Output (Z Direction)	±2.5 VDC
Full Scale Output (X and Y Direction)	±5 VDC
Discharge Time Constant (Z Axis)	≥50 sec
Discharge Time Constant (X or Y Axis)	≥500 sec
Excitation Voltage (all channels)	20 to 30 VDC
Constant Current Excitation (all channels)	2 to 20 mA
Output Impedance	≤100 Ohm
Output Bias Voltage	8 to 14 VDC
Spectral Noise (1 Hz)	0.00134 N/√Hz
Spectral Noise (10 Hz)	0.000668 N/√Hz
Spectral Noise (100 Hz)	0.000223 N/√Hz
Spectral Noise (1000 Hz)	0.0000668 N/√Hz
Spectral Noise (1 Hz)	0.00668 N/√Hz
Spectral Noise (10 Hz)	0.00245 N/√Hz
Spectral Noise (100 Hz)	0.000891 N/√Hz
Spectral Noise (1000 Hz)	0.000245 N/√Hz
Output Polarity	Positive
Physical
Preload	22.25 kN	[5]
Stiffness (Z Axis)	1.75 kN/µm	[2]
Stiffness (X or Y Axis)	0.7 kN/µm	[2]
Size - Height	9.90 mm
Size - Length	27.3 mm
Size - Width	24.1 mm
Size - Bolt Diameter	5.21 mm
Size - ID	8.10 mm
Size - Sensing Surface	17.27 mm
Weight	26.27 gm
Housing Material	Stainless Steel
Sealing	Hermetic
Electrical Connector	4-Pin
Electrical Connection Position	Side

All specifications are at room temperature unless otherwise specified.

Product Notes

[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] Sensitivites are for listed preload. Sensitivites may vary ±5% depending on preload used.
[4] Sensitivities are dependent upon supplied bolt.
[5] Preload should be at least 10 times the X and Y operating range used.
[6] See PCB Declaration of Conformance PS023 for details.

Accessories:

標準付属アクセサリ

081A70	ﾏｳﾝﾄｽﾀｯﾄﾞ
082B02	ｱﾝﾁﾌﾘｸｼｮﾝﾜｯｼｬｰ
083A10	ﾊﾟｲﾛｯﾄﾌﾞｯｼﾝｸﾞ

推奨アクセサリ

034G10	ｹｰﾌﾞﾙ4線10FT(4PIN/BNC)
034G20	ｹｰﾌﾞﾙ4線20FT(4PIN/BNC)
034G30	ｹｰﾌﾞﾙ4線30FT(4PIN/BNC)
482C05	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ
482C15	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ(ｹﾞｲﾝ付）
482C16	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ(可変ｹﾞｲﾝ付）

選択アクセサリ

HCS-QC	校正証明書

Optional Versions:

( W ) Water Resistant Cable

■ Documents & Downloads

Product Documents

● Product Manual

● Product Specification Sheet