260A03 | PCBセンサ・オンラインストア東陽テクニカ

Model: 260A03
Triax ICP® force sensor, 10k lb (Fz), 4000 lb (Fx,y), 0.25 mV/lb (z), 1.25 mV/lb (x, y)

Specifications
アクセサリ
Product Documents

■ Specifications

Performance
Sensitivity (±20 %) (Z Axis)	0.06 mV/N	[3] [4]
Sensitivity (±20 %) (X or Y Axis)	0.28 mV/N	[3] [4]
Measurement Range (Z Axis)	44.48 kN
Measurement Range (X or Y Axis)	17.79 kN
Maximum Force (Z Axis)	48.93 kN
Maximum Force (X or Y Axis)	19.57 kN
Maximum Moment (Z Axis)	325.4 Nm
Maximum Moment (X or Y Axis)	440.6 Nm
Broadband Resolution (Z Axis)	0.222 N-rms	[2]
Broadband Resolution (X or Y axis)	0.044 N-rms	[2]
Upper Frequency Limit	39000 Hz
Low Frequency Response (-5 %) (Z-Axis)	0.01 Hz
Low Frequency Response (-5 %) (X or Y Axis)	0.001 Hz
Non-Linearity	≤1 % FS	[1]
Cross Talk (between X and Y Axis)	±3 %
Cross Talk (between (X or Y Axis) and Z Axis)	±5 %
Environmental
Temperature Range	-54 to +121 °C
Electrical
Full Scale Output (Z Direction)	±2.5 VDC
Full Scale Output (X and Y Direction)	±5 VDC
Discharge Time Constant (Z Axis)	≥50 sec
Discharge Time Constant (X or Y Axis)	≥500 sec
Excitation Voltage (all channels)	20 to 30 VDC
Constant Current Excitation (all channels)	2 to 20 mA
Output Impedance	≤100 Ohm
Output Bias Voltage	8 to 14 VDC
Spectral Noise (1 Hz)	0.0133 N/√Hz
Spectral Noise (10 Hz) (X & Y)	0.00445 N/√Hz
Spectral Noise (100 Hz) (X & Y)	0.00178 N/√Hz
Spectral Noise (1000 Hz)	0.00044 N/√Hz
Spectral Noise (1 Hz) (Z)	0.089 N/√Hz
Spectral Noise (10 Hz) (Z)	0.0222 N/√Hz
Spectral Noise (100 Hz) (Z)	0.0089 N/√Hz
Spectral Noise (1000 Hz) (Z)	0.00222 N/√Hz
Output Polarity	Positive
Physical
Preload	178 kN	[5]
Stiffness (Z Axis)	6.8 kN/µm	[2]
Stiffness (X or Y Axis)	2.0 kN/µm	[2]
Size - Height	20.07 mm
Size - Length	57.1 mm
Size - Width	57.1 mm
Size - Bolt Diameter	25 mm
Size - ID	25.98 mm
Size - Sensing Surface	45.72 mm
Weight	271 gm
Housing Material	Stainless Steel
Sealing	Hermetic
Electrical Connector	4-Pin
Electrical Connection Position	Side

All specifications are at room temperature unless otherwise specified.

Product Notes

[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] Sensitivites are for listed preload. Sensitivites may vary ±5% depending on preload used.
[4] Sensitivities are dependent upon supplied bolt.
[5] Preload should be at least 10 times the X and Y operating range used.
[6] See PCB Declaration of Conformance PS023 for details.

Accessories:

標準付属アクセサリ

081A71	ﾏｳﾝﾄｽﾀｯﾄﾞ
082B06	ｱﾝﾁﾌﾘｸｼｮﾝﾜｯｼｬｰ
083A11	ﾊﾟｲﾛｯﾄﾌﾞｯｼﾝｸﾞ

推奨アクセサリ

034G10	ｹｰﾌﾞﾙ4線10FT(4PIN/BNC)
034G20	ｹｰﾌﾞﾙ4線20FT(4PIN/BNC)
034G30	ｹｰﾌﾞﾙ4線30FT(4PIN/BNC)
482C05	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ
482C15	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ(ｹﾞｲﾝ付）
482C16	4CHｼｸﾞﾅﾙｺﾝﾃﾞｨｼｮﾅ(可変ｹﾞｲﾝ付）

選択アクセサリ

HCS-QC	校正証明書

Optional Versions:

( W ) Water Resistant Cable

■ Documents & Downloads

Product Documents

● Product Manual

● Product Specification Sheet